Subcategories

• 

  REFRACTORY SUPPORTS

  Wide range of tripods, rooster legs, allowing you to carry out and particularize the charging of your kiln.
  
  We also offer plate holders, as well as a set of low and high temperature jewelry holders.

• 

  BARS

  Bar or rod in refractory steel for low temperature and high temperature alumina for firing support for ceramic parts such as jewelry.

• 

  CONES & TEMPERATURE DICS

  Cone and temperature control rings or disc
  
  Fuse Cone allow you to check that the temperature has been reached.
  
  It is preferable to use 3 cones of different temperature, for example for cooking at 1280 ° C, use the free-standing watch N ° 8 (1271 ° C) N ° 9 (1280 ° C) and N ° 10 (1310 ° C) so you will have a precise idea of the temperature reached.
  
  The Temperature Control Ring allows cooking control, recording very precisely the heat actually received by the fired part, both by radiation and by heat transfer.
  
  The rings can be placed on the charging plates, on the parts themselves or next to the temperature sensor to control it.
  
  The measurement of the diameter of the ring, after cooling the oven, gives you the temperature reached by the oven in the area where the ring is placed.

• 

  CASTLE PROP & TUBULAR PROP

  Kiln castellated prop (Interlocking Hollow Support), charging plate support, refractory 1320 ° C max
  
  These pins (Castellated Prop 1½) are superimposed, to allow you to separate the oven plates at the desired height.
  
  Round refractory keel (tubular kiln props) , shelf support, in Alcorit 1350 ° C

• 

  TUBS PROP

  1400 ° C type 60 Kiln resistance support tube
  
  Diameter from 10 mm to 40 mm
  
  Length 450mm to 1600mm or cut on demand.

• 

  TILES CRANKS

  Refractory gazettes for cooking ceramic tiles.
  
  Maximum temperature 1250 ° C

• 

  KILN SHELVES

  Charging refractory plates for kiln (Shelve Batt).
  
  Refractory plate Alcorite 1280 ° C, Mulcorit 1340 ° C, Silicon carbide recrystallized 1600 ° C or not recrystallized 1400 ° C.
  
  Square, rectangular and round format.
  
  Cut on demand.

• 

  REFRACTORY MORTARS

  Glue and refractory mortars adhesive.
  
  Glue paste 1450 ° C and 1600 ° C, refractory concrete powder 1300 ° C, insulating paste cartridge 1400 ° C for repairing cracks and slip for charging (engobe) plate.